DIY: Adding custom 3D logos to my 2021 Force Gurkha

I measured the inside diameter of the LED headlamps of the Gurkha. These are 6 inches in diameter.

BHPian Manuuj recently shared this with other enthusiasts.

The 3D Logo for the center of the grill has that design. Its in 2 parts. First the lower part will get screwed into the center bar of the existing grill and then the "Khukri in Ring" part will go on top.

The "Khukri in Ring" part may or may not get painted the same color as the alloys wheels along with the G U R K H A bonnet alphabets. Both are currently silver.

Will take a call on that later.

I measured the inside diameter of the LED headlamps of the Gurkha. These are 6 inches in diameter.

I believe the center logo should be slightly smaller than the headlights to look visually appealing so decided that the lower disc (wrapped in faux carbon fibre) will be of 5 inches diameter.

This has a hole in the center, besides the 3M backing tape so it can be screwed on to the center bar of the existing grill, on which the GURKHA chrome badging currently is.

The upper "Khukri in Ring" is slightly smaller than the carbon fibre disc and will sit on top of the carbon fiber disc in the center if the grill once the current chrome GURKHA letters are removed.

Check out BHPian comments for more insights and information.