|
Originally Posted by PrisonMike
(Post 5489413)
Hi guys Has anyone had any experience with the Sachs shock absorbers for the Polo? Apparently these are the ones that come OEM fitted in the European Polos, and are said to feel more robust and more stable during cornering compared to the stock ones we get here. I've been on the look out for a few set of shocks now since I feel like my car seems to feel like it's 'crashing' over sharp bumps. |
Originally Posted by suhaas307
(Post 5495309)
I have had some experience with these dampers. I highly recommend them... |
Originally Posted by suhaas307
(Post 5495309)
I have had some experience with these dampers. I highly recommend them, even more than Bilstein's B4 or B6. They are somewhere in between B4 and B6 I would say. The ride becomes firm but the damping is on-point. Expect the ride height to get jacked up by an inch or so. If that does not bother you, these are in my opinion the best dampers for the car. |
Originally Posted by tbppjpr
(Post 5495357)
Where can they be bought in India? Saw Sachs shock absorbers on Boodmo sometimes ago, IIRC priced at around 3-4K per piece, are they genuine? |
Originally Posted by PrisonMike
(Post 5495379)
Thank you for your input! Does this absorb sharp bumps and speed breakers better than the stocks? I'm honestly getting a little tired with the stock setup now, and almost dreading going over bumps and potholes now because they seem to rattle my bones a bit too much. |
Originally Posted by s4ch
(Post 4831329)
A question, wondering if anyone has faced this before: My Polo seems to have a problem with charging the battery. Recently put in a new Amaron battery, however within a week or 2 used to get the notification on the media unit saying the battery is low. Also the lights would occasionally flicker when using the AC/wipers or putting a load on the electrical circuit. Then eventually the battery went completely flat and I was not able to start the car. Today, I used a powerbank jumpstarter, and it started immediately. However after driving around for almost an hour, came home parked the car, and tried to use it again 15 mins later and it was completely dead again, not even enough juice for the car to unlock using the fob. So I am thinking the alternator probably has some problem? Don't think it is the battery as it is not more than a few months old. Wondering if anyone has faced a similar problem and/or replaced the alternator, and how much this would cost? |
Originally Posted by MartinVirage
(Post 5509684)
Having the same issue on a friend's GT TSi. Any solutions on this issue. He has an non-VW fitted Exide Battery which we got changed under warranty. Any inputs will be very helpful. Offcourse VW After sales say everything is fine - no issues at all. |
Originally Posted by PearlJam
(Post 5509872)
When I press the brake pedal of my Polo 1.2 TSI, to start the car after around 24 hours of halt, the brake pedal is hard. Once it starts, the pedal as well as braking are perfectly fine. The pedal is also fine on switch off and start in the same day. The fluid levels are also all fine. Looks like some loss of suction overnight (for lack of a better word). This started happening recently. Any suggestions on the diagnosis, and whether it's an issue at all? Thanks! |
Originally Posted by Traveler
(Post 5495251)
I plan to put it for sale in March. Haven't tried getting it evaluated at the moment. |
Originally Posted by CANPUSH
(Post 5516657)
Eagerly awaiting update. That will give decent clue to other owners too. |
Originally Posted by veyron999
(Post 5364159)
strong vibration when the engine RPMs are in between 3000-3500. The vibration dies down after that. There are more posts on similar vibrations, but haven't found anything conclusive yet. I noticed that this is there on a lot of cars, but in varying degrees. Mine being on the higher side. |
Originally Posted by veyron999
(Post 5380237)
The vibration at 3-3.5k seems to be there in most of the cars, but more pronounced in some cases. Last week I went to the svc again, and got this checked yet again. One of the technicians took a long screw driver, and held one end against the non-rotating parts of different bearings, and the other part against his ear, while the engine was running. He then realised that the tensioner bearing had a significant vibration emanating out of it |
All times are GMT +5.5. The time now is 20:01. | |