Team-BHP
(
https://www.team-bhp.com/forum/)
I purchased the
MICHELIN 12266 for INR 4,499 in Dec 2023. Interestingly, the same unit is now available for INR 3,995 on Amazon.in and I feel this will be a really good addition to any home. I was largely impressed by the
review posted by
Aditya way back in 2022 and finally decided on this unit after going through reviews of multiple units online as well as speaking with folks who owned such inflators.
It easily inflated a flat tyre on the Nissan Sunny to 33psi inside of three minutes. Yes, it is noisy but you kind of get used to it after a while. The 12V cable is fairly long and coupled with the air hose, you can easily reach all four tyres. I just wish it had an AC input as well, as you are constrained to using a 12V source for power. The unit doesnt dance around while operating, and doesnt heat up either after long operation.
I dont particularly like the fact that you have to screw the nozzle in and out, but apparently a
handy solution is available on Amazon.in
Quote:
Originally Posted by sapien
(Post 5751940)
Whats your review on Michelin one, is it holding up well?
|
Hi, I have been using for more than a year now and it’s working fine. I use it on Tata Safari and it can fill all the four tyres in a matter of 10-15 minutes. Doesn’t make much noise or vibrations. Pretty handy to use.
Quote:
Originally Posted by sapien
(Post 5751940)
Any thoughts on 85 vs 87 vs 88. 88P is the most powerful as per SwastikFabs.
Based on suggestion by BHPian Sommos, started looking at VIAIR 87P, and this turned out to be very reliable and powerful, just that it doesn't have auto stop etc features, also an analogue pressure guage. Not sure if I can fill bicycle tyres etc with this. But this comes as strongly recommended and sells in matured markets like US. When I called up SwastikFab they recommeded going for 88P as its more powerful and fills air quickly. The only negative point about VIAIR is high price. But, the person on call was super confident saying this is a lifetime product and he hasn't done a single replacement till date. Probably this will last much longer and hence cover up the price of 2 such inflators which I may end up buying in the same time period. I am strongly considering 87P/88P - how long does it take for 87P to fill a tyre from 20 psi to 33 psi ?
|
I have been using VIAIR 90P for last 3 months, after my previous GoMechanic inflator, which was gifted by someone, stopped working after just 3 uses. 90P is extremely fast, does not sound strained even a little bit even when filling the whole tyre. I use it with my cars and bicycles.
I evaluated 87P, 88P and 90P before my purchase - the feedback that I got from friends in US was that there is not much difference in the fill rates, 88P being the is the most powerful of the lot. 235/55/R18 tyres of my Kodiaq fill up from empty to 35PSI in under 3 minutes with 90P. (Another 30-40 seconds would not really matter much anyway). Also, I got consistent personal feedback that these long-lasting products, and do not go bad easily. I would suggest 88P over 87P since 88P is rated at 120PSI - a product rated for higher pressures would be more resistant to wear and overheating. Also, rated pressures for road and hybrid bicycle tyres often go above 60PSI and that would be important if you want to use the inflator with such tyres. 88P also comes with Presta adapter (not a big deal - Schrader to Presta adapters are cheap).
I was looking for 88P, but got 90P since 88P was not in stock at that time. I guess the only thing that 88P does not have that is in 90P is a bleeder valve on the tyre connector - the valve makes it easier to adjust pressure accurately.
Purchased GoMechanic Gusto T10 Digital Tyre Inflator (150 psi, 12V DC) in November 2023 from
Amazon. Major reason for choosing this product was that it was made in India.
Have used it for topups of 2-3 psi a handfulof times; no occasions so far (thankfully) when I had to inflate a flat tyre. Observations:
- Fast - took just about 6-7 minutes for topping up all 4 tyres
- Did not heat up
- Did not need to start the car engine while topping up, did not drain the battery
- Noise levels seem ok
Quote:
Originally Posted by adisan
(Post 5752843)
Did not need to start the car engine while topping up, did not drain the battery
|
But I think you
should only use a 12v inflater with the engine running.
Pretty sure the instructions on mine state to start the engine before even plugging it in. It might be a necessity too, if one's 12v socket is not even live without the engine running.
Quote:
Originally Posted by adisan
(Post 5752843)
[*]Did not need to start the car engine while topping up, did not drain the battery [*]Noise levels seem ok[/list]
|
Quote:
Originally Posted by Thad E Ginathom
(Post 5753149)
But I think you should only use a 12v inflater with the engine running.
Pretty sure the instructions on mine state to start the engine before even plugging it in. It might be a necessity too, if one's 12v socket is not even live without the engine running.
|
Actually one must start the engine to use the inflator. A car without the engine running delivers ~ 12.3- 12.5V while a car with its engine on will deliver ~14.1- 14.4V through the 12V socket. So, a running engine will stress the electrical system much less as the current draw in amps will be XX watts/ 14.4V as compared to XX watts/ 12.5V. You can even blow the fuse if the current draw of the inflator is on the borderline of what the socket supports if the engine is not running.
Looking to buy a Tyre Inflator for our XUV700, hence did some research around same. Found tremendous amount of information in these
thread1,
thread2. Got a lot responses from BHPians, but there are variety of options which are good and in a wide price band. This is has led to more confusions, hence to get some quantitative results, starting this poll, requesting everyone to vote based on their personal experience. Note I have also added Woscher 802D in list which is not present in below comparison-
How about having such polls for all the common accessories like Inflators, Vaccums, Dashcams, Pressure wash guns etc ? It can act as 1 stop resource for anyone looking to buy the same - that too backed by BHPians real experiences!
If you are going to use it as an emergency device or a once in a few weeks top up device - then a small rechargeable one like an Mi tyre inflator is best. Its a compact unit and its accurate, there is no need to access the vehicle \ plug it into the socket etc.
For Offroad use you need something like the ViAir with battery clamps.
Using the Bergman Digital which is posted above for little over 2 years and it is performing brilliantly.
It comes with metal barrel unlike the counterparts. It fills up the tyre pretty quickly and yes of course it does get hot by the time you top up all 4 tyres.
Speaking about the build quality it is sturdy, comes with a small torch which is really helpful and most importantly the pump sticks to the ground when it is ON and doesn't move around on its own.
The Viair will outlast my cars and even me! It's epic build should also count in terms of never having to ever buy again.
Good comparison, I would also like to include other key technical parameters like 0-30 PSI in how many seconds? Apologies, I don't know the technical term for that.
I found SwasthikFabs overpriced for all the stuff that they sell.
I have four tyre inflators at my home
- Good Year tyre inflator - Purchased from PayTm for INR 1600 in 2014; did not last two months.
- TIREWELL TW-7001 12V Digital with LED Light and Three Different Nozzles (TW-7001) - Purchased on Amazon in 2018. It is permanently stored in my Scorpio Classic and still works; I use it almost every week. The current Price is INR 1900.
- Amazon Brand: Solimo Portable Tyre Inflator, 12V Analog - Purchased from Amazon in 2021 and 2023. One stays in Scorpio-N, while another is often switched between Jimny and XUV5OO. I use it on occasion and it works great. The current price is INR 1150.
Quote:
Originally Posted by sapien
(Post 5758592)
This is has led to more confusions, hence to get some quantitative results, starting this poll, requesting everyone to vote based on their personal experience.
|
I'm using the analog tyre inflator from Bergman since 2018. It is still working perfectly with no signs of ageing. The hose length is one of the longest I've seen across multiple brands.
I went for the analog model since, it is the least complicated and has lesser components for failure. I'm using a separate high accuracy pressure guage alongside for measurement.
Couple of my friends bought the same model ( after seeing mine) and are happy with their purchase.:thumbs up
One point you may want to check (that is missing from the comparison table) is the ability to set a target pressure and the pump stops once that is sustained. This is not there in many Michelin models and even the basic Amazon Solimo has this which is quite useful.
| All times are GMT +5.5. The time now is 19:25. | |
