sorry for delay, lots happened in the meanwhile
On receipt of the letter, I get a call saying the ribbed belt had arrived. There was a misunderstanding, they got the fan belt. Luckily, they had the cashaft belt on hand all this time.
Car got booked in and job was duely done. Total cost was Rs 9900. The tensioner was not replaced. Luckily the life of this is a lot longer so I will do this later. Was a stich in time as the belt was gettiing a bit hard.
I take deliver and then get this note.
Quote:
We would also like to inform you that the Clutch, Oil sump, water pump and ribbed belt tensioner in your vehicle need attention. The same has been updated in the jobcard also.
Requesting you to get these parts replaced at earliest.
|
Clutch - although no slippage was getting temperamental when changing gear and the watchman was complaining that oil was drippping. So far, we had been getting away with Mseal but this was not holding up so time ot bite bullet.
Popped into Vinayak and they were insisting on changing the flywheel. I dug my heels in. There is not slippage, it is the pressure plate which is playing up. (actually , they had ordered both flywheel and clutch).
Booked car in, on the way to handing over car, the EPC light came on and car started spluttering - fuel starvation. I connected the laptop and drove on and cancelled the codes. I switched AC on and car was ok except EPC light. Faults pointed to throttle body
Checked car in - Abi clearly made sure that flywheel would not be replaced. instructed that the TB to be cleaned. Job took over a day. On the next day, they completed everything but could not get the car to run smoothly. Bill was Rs 26000. Rs 8500 for the sump, Rs 15000 for clutch and Rs 2000 for labour, rest for taxes and sundries. Clutch was wearing out. I had another 5000km. If I over did it, it would have damaged flywheel
Am told - Coil packs 1 and 4 need to be replaced - I told them to interchange with 2 and 3. They did that but no luck. Deja Vu since it was post no 99 happening again. Told them to realign the throttle body. I was told it had been done
Collected the car. I needed to be in office for a night meeting. It was rough unless I had the turbo on. Work over, I drove the car home. Lack of traffic meant it could get home without a hitch. Hoever, it was idling at 1500rpm and hunting.
Next day morning, i scanned the car - misfire, higher idle, pressure drop at dump valve. These were all results and the causes. With a sigh, I cancelled the codes, did the TB adapation and alignment online. Went in to get ready for work.
Took a deep breath and started the car......it was smooth. 150km on, the car has been fine.
Looks like Vinayak are not aware about the need for TB relignment.
and so
![Frustration](https://www.team-bhp.com/forum/images/smilies/Frustration.gif)
why do I persist with this car
1: Actually things are not too bad. I have bit a bit over proactive
2: No other car gives the mid range acceleration and poise for the money
3: It is solid and safe
4: It is comfortable
Frankly, the water pump, fan shorting have been the main issues. The clutch can be attributed to working conditions.
finally - the service advisor conceded that the flywheel was perfectly fine and was amazed with the collective t-bhp knowledge behind me! Asked me to teach him a few things about the car!